Step 5: App-Specific Setup Guides

Some apps require configuration before you can start utilizing them. In most cases, apps get set up at start-up and will run automatically from there.

Cycle Counts Integrations

Set up a report, integration, and workflow to automatically create Count orders.

Documentation for each of these steps is available here.

Data Push Integrations

Set up integrations in the Data Push app to start exporting transactions from PowerPick to your ERP.

Documentation is available here.

In addition to the documentation linked above, there's also a step-by-step course on setting up Data Push.

Each integration has its own settings and mappings, so be prepared to spend a bit of time entering these details.

Make sure to activate your integrations when you've tested them and are ready to go.

Note: If you haven't already set up the connection settings for Data Push, check back to Step 2.

 

Epicor Integrations

Set up integrations in the Epicor app to determine how information between Epicor and Itempath will be transferred. Each integration has its own settings and mappings, so be prepared to spend a bit of time entering these details.

Documentation is available here.

---